Carbon Steel Butt Welding Pipe Fitting LR Elbow

45 degree Stainless Steel Elbow is different from Carbon Steel Elbow is mainly the difference in material, the chemical composition it contains will keep the surface of the elbow for a long time will not rust, will not be corroded. According to the standard production can be divided into.      

1. Divided by manufacturing standards can be divided into national standards, ship standards, electric standards, water standards, JIS/DIN/ASME/GB.　

2. Divided by the production method can be divided into pushing, pressing, forging, casting, etc.   

　　45 degree stainless Steel Elbow is mainly used for pipeline installation in a connection pipe fittings, for the connection of the pipe Bend. Connect two nominal diameter of the same or different pipe, so that the pipeline for 45 degrees of stainless steel elbow.

　　Usually in carbon steel based on the increase of a high proportion of Cr, Ni and other alloys and become, the proportion of content up to 20% or more. Common steel grades are: 304, 304L, 321, 316, 316L, the first few with the number of steel for Japan, the United States steel number to indicate the method, a domestic steel number to indicate the method.  

45 degree stainless steel elbow characteristics: strength, toughness indicators are good in a variety of steel, its outstanding advantage is corrosion resistance, in the chemical industry and paper and other corrosive occasions must use stainless steel, of course, the cost is also higher!

Elbow is a common connection pipe in the pipeline，it is often used to change the direction of a pipe.Divided by Angle, the common elbow Angle is 45, 90, 180 of these three, because of different design and construction needs we often provide all customized services for customers.Classified by radius, elbows can be divided into long radius and short radius elbows.We mainly produce and sell metal elbow, such as: cast iron, carbon steel, stainless steel, zinc alloy, titanium alloy and so on. We have many large and small elbow moulds to meet your different needs under ASME/ANSI JIN DIN EN GB and other standards.We have a wide range of molds for elbow sizes to meet your different needs.Elbow can be divided into long radius and short radius according to the radius.After forming the elbow, it needs to be polished and bevelled in the later stage.Of course, surface treatment is also a very important link, we can provide: black paint, green paint, sand blasting, galvanized, epoxy coating, 3PE, anticorrosion and so on surface treatment process, to meet your different use environment needs.Professional and attentive, we look forward to cooperating with you.

Other products: 
45 Deg BW LR Elbows 
Q235 CS CONC Reducers
Galvanized Equal Tees